1. Core specification model
analysis: HZ:
Chemical heavy-duty centrifugal pump
series 150/100: DN150 inlet/DN100 outlet DSA: Special alloy (Super Alloy) Flow component type: Horizontal/vertical carbon transfer pump (optional)
Design standard: GB/ T5656/HG/T3183
2. Process performance
| 规范 | Scope of indicators |
| internet traffic | 80-220m ³/h (variable frequency adjustable) |
| lift | 25-55m |
| Maximum allowable solid content | 45% (weight ratio) |
| medium temperature | ≤ 120 ℃ (high temperature type can reach 180 ℃) |
3.Wear-resistant and anti-corrosion design
Flow-through parts:
Pump casing: Cr30 high chromium alloy lining (hardness ≥62HRC)
Impeller: Bidirectional adjustable wear-resistant impeller (life ≥8000h) Sealing system:
Triple seal: mechanical seal + packing seal + nitrogen barrier
Leakage: ≤5ml/h (in line with API682 standard)
4.Power configuration
Motor options: Standard: Y2-315M-4 (132kW, 1480r/min)
Explosion-proof:YBX3-315M-4W (Ex dⅡ BT4)
Transmission mode:elastic pin coupling direct connection
5.Special process adaptation
Leaching characteristics optimization:
Acid resistance range: pH1-14 (optional lining PO/PTFE)
Anti-crystallization design: built-in flushing water ring
智能控制：
Configure pressure flow PID regulation system
Bearing vibration online monitoring (4-20mA output)
6.Installation dimensions Basic
installation drawing:
Flange standard: HG/ T20592 (RF)
Center height:650mm
Foot spacing: 900×600mm
7.Maintenance indicators
Overhaul cycle:
Normal working conditions: 8000 hours Strong corrosion conditions: 5000 hours List of wearing parts:
Mechanical seal (replace every 6000h)
Liner （depending on the condition）
Selection comparison table
| configuration item | Economic type | Enhanced |
| 材料 | Cr27 high chromium alloy | Tungsten DLC Coating |
| seal | Double mechanical seal | Dry gas sealing system |
| price | | |
Typical fault handling
1.Flow drop:
Check the impeller clearance (should be maintained at 0.5-1mm)
Verify the clogging of the inlet filter
2.Abnormal vibration:
Check the bearing wear (allowable vibration value ≤4.5mm/s)
(Note: It is recommended to match the Y-type filter (mesh number ≥20) and soft start device to extend the service life)
