1.Основные характеристики
Model Analysis
HZV: may stand for Submersible Pump (H) + Vertical Mounting (Z) + Special Design (V)
40: Rated flow rate (40m³/h)
P: may represent cast iron material (P for cast iron, S for stainless steel, etc.)
Type: Submersible centrifugal pump (suitable for sump, drainage pit, etc.)
Installation method: fixed/mobile (with automatic coupling device)
2.Performance parameters
Flow rate (Q): 20-50m³/h (optimal operating point 40m³/h)
Head (H): 10-25m (adjusted according to the impeller series)
Power (P): 37.5kW (commonly used 4kW/5.5kW, 380V -50Hz)
Speed: 1450-2900r/min (4-pole/2-pole motor)
Maximum diving depth: ≤10m (depending on cable length and sealing level)
3.Structure and material
Pump Material:
Cast iron (HT200) / stainless steel (304/316L, corrosion resistant)
impeller:
Closed/semi-open impeller (cast iron/stainless steel/nylon reinforced material)
Anti-clogging design (suitable for sewage containing impurities)
Sealing system:
Double mechanical seal (SiC/Carbon pairing)
Oil chamber leakage sensor (optional)
4.Applicable medium Liquid Type:
Clean water, rainwater, sewage (containing a small amount of solid particles ≤20mm)
Mildly corrosive liquids (pH 410, stainless steel models can be extended to pH 212)
Liquid temperature: ≤40℃ (high temperature requires special design)
Solid content: ≤5% (weight ratio)
5.Control system (optional)
Automatic start and stop: float switch/liquid level sensor control
Protection function:
Overload, phase loss, water leakage alarm (IP68 protection level)
Dry running protection (need to be matched with sensor)
6.Размер и вес оборудования
Outlet diameter: DN50-DN80 (flange connection, standard GB/T 9119)
Machine weight: 50-120kg (depending on material and power)
Overall dimensions (diameter × height): ≈φ200-300mm×500-800mm
7.Special configuration (optional)
Explosion-proof model: Ex dⅡ BT4 (suitable for flammable and explosive environments)
Wear-resistant design: impeller sprayed with tungsten carbide (for sandy water)
Remote monitoring: 420mA signal output (integrated IoT module)
Key Considerations
1.Selection points:
When there are fiber impurities, a cutting device must be installed (such as HZV40PC model)
For highly corrosive environments (such as seawater), 316L stainless steel is recommended.
2.Installation requirements:
The bottom is ≥0.5m from the bottom of the well to avoid sand inhalation
The automatic coupling device must be used with the guide rail
3.Maintenance cycle:
Check the seal every 6 months
Long-term out of use requires hoisting and storage
Типичные сценарии применения
Municipal Engineering: Drainage of underground garage water collection well
Industry: factory waste water pits, cooling water recovery
Construction: foundation pit dewatering, tunnel drainage
For more detailed performance graphs (QH curves) or cable length options, please provide specific operating conditions (such as sand content in the medium, continuous operating time, etc.).
