Seau de collecte de concentré de 1m².

1. spécifications de base

Model example: JC-1.0 (different manufacturers have different numbering rules)

Effective volume: 1m³ (including buffer space)

Processing capacity: 5-15t/h (adjusted according to concentrate density)

Design pressure: normal pressure (0.5~+5kPa)

2. Paramètres structurels

composante	spécifications
Material	Q235B+NM400 wear-resistant lining plate (δ=68mm)
Discharge port size	DN200-DN300 (customizable)
valve type	Pneumatic/manual wear-resistant gate valve
Leg height	800-1200mm (with maintenance space)

3. Slurry adaptability

Maximum particle size: ≤5mm (recommended to use a slag removal screen) Viscosity range: ≤2000cP (high viscosity requires additional vibrator)

pH tolerance: 2-12 (corrosive media require 316L stainless steel)

4.Control and power Drive mode:

Electric actuator (0.75kW, IP65 protection) Optional pneumatic control (0.4-0.6MPa air source) Automation features:

PLC proportional distribution control (accuracy ±5%) Real-time monitoring of slurry flow (420mA signal output)

5 Equipment size

paramètre	Typical values
Length×Width×Height	1200×1000×1500mm
weight	300-500kg

6. Selection Recommendations

1. High wear conditions (such as iron ore concentrate):

Use Cr27 high chromium cast iron lining (lifespan increased by 2-3 times)

2. Corrosive media (such as copper concentrate): All 304/316L stainless steel (acid and alkali resistant)

3. Points d'entretien :

Check the wear of the lining every week

and clean the accumulated material at the discharge port every month

(Note: The actual selection requires the specific parameters such as the specific gravity of the concentrate and the particle size distribution)