1. . Basic specification
model analysis:
FAT: may stand for flocculant agitation tank (Agitation Tank) 2×2: tank diameter 2m × height 2m (or double tank parallel design, to be confirmed)
Type: mechanical agitation flocculation tank (continuous/ intermittent operation optional)
Effective volume: about 6m³ (calculated as a cylinder,the actual volume needs to deduct the space occupied by the agitator)
2. Agitation system
parámetro index Blender type Slant propeller/turbine type (depending on flocculation requirements) Motor Power 3-7.5kW (variable frequency control) speed range 50-150r/min (low shear design) material 304/316L stainless steel (corrosion-resistant)
3. Structural design Tank material:
Carbon steel lining rubber/PP/PE (acid and alkali resistant)
Optional all stainless steel (food/ pharmaceutical grade)
Heating/cooling: Jacket or coil design (temperature control range 20-80℃)
Sealing: Flange connection (IP54 protection grade) Optional nitrogen protection (anti- oxidation)
4.Process adaptability
Flocculant type: PAM, PAC, etc. (viscosity ≤500cP)
Mixing effect:
Uniformity ≥95% (passed dye tracer test) Floc particle size control: 0.5-5mm (adjustable)
5.Control and automation
PLC system:
Real-time monitoring of pH, temperature, and speed
Support Modbus communication (connected to DCS)
Safety protection: overload alarm, liquid level interlock
6.Equipment size and Selection
parámetro Data Overall dimension ≈2500×2500×3000mm weight 1.53t (depending on material)
Model selection recommendations
1. Highly corrosive conditions: Choose PP lining + titanium alloy stirring shaft.
2. Viscous flocculants: Configure anchor agitators to prevent dead corner accumulation.
3. Puntos de mantenimiento:
Check lining wear every quarter (thickness < 3mm needs to be replaced)
Lubricate bearings (water-resistant grease, replaced every 2000 hours)
If a flow field simulation report or customized solution is required, please specify the specific process conditions (such as flocculant concentration, processing volume, etc.).
